I was running with --verbose, but not --debug. I'll try that when the
machine is back up on Wed.
Has anyone else seen this behavior?
On Oct 2, 2006, at 9:57 AM, Jeff Squyres wrote:
> Hrm. Well, the lack of "success=1" is why it didn't run, but then the
> larger question becomes "why didn't it succeed?".
> Do you have --verbose or --debug output for the build, perchance?
> If it
> failed to build, there should be some output about it.
> On 10/1/06 7:32 PM, "Josh Hursey" <jjhursey_at_[hidden]> wrote:
>> So I dug into this about as much as I can, and found that the v1.1
>> build seems to have completed successfully, but doesn't contain the
>> 'success = 1' line. I attached the build dumps in case that helps
>> figure this one out.
>> Any thoughts on why this might happen,
>> On Sep 29, 2006, at 3:40 PM, Josh Hursey wrote:
>>> Has anyone been using MTT to test the v1.1 nightly?
>>> I have been trying to run the [trivial,ibm] tests against
>>> [trunk,v1.2,v1.1]. MTT will build all the sources and all the tests
>>> with all the sources. It will then run the trivial tests against all
>>> three sources, but only the ibm tests against the trunk and v1.2.
>>> I looked at the logs produced and there didn't seem to be any errors
>>> with the ibm+v1.1 test build. Would there be any other reason this
>>> would happen?
>>> Josh Hursey
>>> mtt-users mailing list
>> Josh Hursey
>> mtt-users mailing list
> Jeff Squyres
> Server Virtualization Business Unit
> Cisco Systems