On Thu, Jul 18, 2013 at 08:33:37AM -0700, Ralph Castain wrote:
> On Jul 18, 2013, at 8:17 AM, "David Goodell (dgoodell)" <dgoodell_at_[hidden]> wrote:
> > On Jul 18, 2013, at 9:53 AM, Ralph Castain <rhc_at_[hidden]> wrote:
> >> On Jul 18, 2013, at 7:05 AM, David Goodell (dgoodell) <dgoodell_at_[hidden]> wrote:
> >>> On Jul 18, 2013, at 8:06 AM, Ralph Castain <rhc_at_[hidden]> wrote:
> >>>> That's a good point, and a bad behavior. IIRC, it results from the MPI Forum's adoption of the MPI-T requirement that stipulates we must allow access to all control and performance variables at startup so they can be externally seen/manipulated.
> >>> Minor nit: MPI_T does not require this. However, it does recommend that you offer users access to as many variables as possible as early as reasonably possible for the convenience and control of the user.
> >>> If an implementation chooses to offer 5% of the possible control/performance variables to the user just before MPI_Finalize, that's still a valid MPI_T implementation. But it may not be a very useful one...
> >> The problem here is one of use vs startup performance. George is quite correct with his concerns - this behavior would have been a serious problem for RoadRunner, for example, where we had a small IO channel feeding a lot of nodes. It will definitely become an issue at exascale where IO bandwidth and memory will be at a premium.
> > My point was not that the performance concerns were unfounded. Rather, I wanted to point out that the "load everything" behavior is not a hard requirement from the MPI standard, so we have room for different implementation choices/tradeoffs.
> I understood - I was more just pointing out the potential performance issue of load everything. However, Nathan has addressed it by pointing out that the problem is my aged, fading memory.
So, I think what I can take from this discussion to to make the following changes to ompi_info:
- Make --all without a --level option imply --level 9.
- Allow the user to modify this behavior by specifying a level: ex --all --level 5 would print every variable up to level 5.
I will make these changes today and CMR them into 1.7.3 unless there are any objections.