Thanks a lot, I m implementing the passwordless cluster
I m also tryin different benchmarking software n got fed up of all the probs in all de sofwares i try. will list few:
1) VampirTrace
I extracted de tar in /vt then followed following steps
$ ./configure --prefix=/vti
[...lots of output...]
$ make all install
after this the FAQ on open-mpi.org asks to 'Simply replace
the compiler wrappers to activate vampir trace' but does not tell how do i replace the compiler wrappers.
i try to run mpicc-vt -c hello.c -o hello
but it gives a error
bash: mpicc-vt: command not found
2) HPL
for this i didnt undersatnd the installation steps.
I extracted the tar in /hpl
Then is asks to 'create a file Make.<arch> in the top-level directory' i created a file Make.i386.
then it says 'This file essentially contains the compilers
and librairies with their paths to be used' how do i put that?
after that it asks to run command make arch=i386
but it gives error
make[3]: Entering directory `/hpl'
make -f Make.top startup_dir arch=i386
make[4]: Entering directory `/hpl'
Make.top:161: warning: overriding commands for target `clean_arch_all'
Make.i386:84: warning: ignoring old commands for target `clean_arch_all'
include/i386
make[4]: include/i386: Command not found
make[4]: [startup_dir] Error 127 (ignored)
lib
make[4]: lib: Command not found
make[4]: [startup_dir] Error 127 (ignored)
lib/i386
make[4]: lib/i386: Command not found
make[4]: [startup_dir] Error 127 (ignored)
bin
make[4]: bin: Command not found
make[4]: [startup_dir] Error 127 (ignored)
bin/i386
make[4]: bin/i386: Command not found
make[4]: [startup_dir] Error 127 (ignored)
make[4]: Leaving directory `/hpl'
make -f Make.top startup_src arch=i386
make[4]: Entering directory `/hpl'
Make.top:161: warning: overriding commands for target `clean_arch_all'
Make.i386:84: warning: ignoring old commands for target `clean_arch_all'
make -f Make.top leaf le=src/auxil arch=i386
make[5]: Entering directory `/hpl'
Make.top:161: warning: overriding commands for target `clean_arch_all'
Make.i386:84: warning: ignoring old commands for target `clean_arch_all'
( src/auxil ; i386 )
/bin/sh: src/auxil: is a directory
then it enters shell prompt.
Please help, is there a simpler Benchmarking software?
i dont wanna give at this point :(