Hi,

 

I am attempting to build openmpi 1.6.2 using a customized toolchain built using yocto for an ARMv5 target.

I build with the following commands with the toolchain in my path

 

CFLAGS=-march=armv5

./configure --host=arm-prysm-linux-gnueabi --build=i686-pc-linux-gnu CFLAGS=-march=armv5

 

However, the build halts after a few minutes with the following error :

 

rm -f atomic-asm.S

ln -s "../../opal/asm/generated/atomic-local.s" atomic-asm.S

  CPPAS  atomic-asm.lo

atomic-asm.S: Assembler messages:

atomic-asm.S:7: Error: selected processor does not support ARM mode `dmb'

atomic-asm.S:15: Error: selected processor does not support ARM mode `dmb'

atomic-asm.S:23: Error: selected processor does not support ARM mode `dmb'

atomic-asm.S:32: Error: selected processor does not support ARM mode `ldrex r3,[r0]'

atomic-asm.S:35: Error: selected processor does not support ARM mode `strex r12,r2,[r0]'

atomic-asm.S:49: Error: selected processor does not support ARM mode `ldrex r3,[r0]'

atomic-asm.S:52: Error: selected processor does not support ARM mode `strex r12,r2,[r0]'

atomic-asm.S:55: Error: selected processor does not support ARM mode `dmb'

atomic-asm.S:67: Error: selected processor does not support ARM mode `ldrex r3,[r0]'

atomic-asm.S:70: Error: selected processor does not support ARM mode `dmb'

atomic-asm.S:71: Error: selected processor does not support ARM mode `strex r12,r2,[r0]'

atomic-asm.S:86: Error: selected processor does not support ARM mode `ldrex r2,[r0]'

atomic-asm.S:88: Error: selected processor does not support ARM mode `strex r3,r2,[r0]'

atomic-asm.S:100: Error: selected processor does not support ARM mode `ldrex r2,[r0]'

atomic-asm.S:102: Error: selected processor does not support ARM mode `strex r3,r2,[r0]'

 

Kindly guide me.

 

Regards,

Anup


CONFIDENTIAL COMMUNICATION -- The information in this e-mail (including any attachments) is confidential and proprietary to PRYSM, INC. and intended only for the sole use of the intended recipient. If you have received this communication in error, then any review, dissemination, distribution, or copying of this message is strictly prohibited, and please permanently delete this message (including any copies of this e-mail and any attachments thereto) and notify us immediately by return e-mail or by forwarding this email to Susan Kent at skent@prysm.com.