Wow thanks a lot guys. I'll try it tomorrow morning. I'll admit that this time when i saw that there are some header files "not found" i didn't even bother going through the all process as I did previously. Could have had it installed by today. Well i'll give it a try tomorrow and come back to you with a confirmation of whether it works or not. For the "virtual cluster", should I select check any of the checkboxes in the red window?
That red window is what you should see after the first Configure step in CMake. You need to do the next few steps in CMake and Visual Studio to get a Windows OpenMPI build done. That's how CMake works. It's complicated because CMake has to be able to build on multiple OSes so what you do on each OS is different. Here's what to do:
As part of your original CMake setup, it will have asked you where to put the CMake binaries. That's in "Where to build the binaries" line in the main CMake window, at the top. Note that these binaries aren't the OpenMPI binaries, they're the Visual Studio project files that Visual Studio uses to build the OpenMPI binaries.
See the CMAKE_BUILD_TYPE line? It says Debug. Change Debug to Release if you want a Release build (you probably do). Press the Configure button again and let it run. That should be all clean. Now press the Generate button. That will build the Visual Studio project files for you. They'll go to the "Where to build the binaries" directory. From here you're done with CMake.
Next you have two options. You can build from a command line, or from within Visual Studio itself. For command-line instructions, read this:
Note that you need to execute the devenv commands in that post from within a Visual Studio command prompt: Start, All Programs, Visual Studio 2008, Visual Studio Tools, Visual Studio 2008 Win64 x64 Command Prompt. I'm assuming you want a 64-bit build. You need to be in that "Where to build the binaries" directory as well.
To use Visual Studio directly, start Visual Studio, and open the OpenMPI.sln project file that's in your "Where to build the binaries" directory. In the Solution Explorer you'll see a list of sub-projects. Right-click the top heading: Solution 'Open MPI' and select Configuration Manager. You should get a window that says at the top Active Solution Configuration, with Release below it. If it says Debug, just change that to Release and it will flip all the sub-projects over as well. Note on the the list of projects the INSTALL project will not be checked. Check that now and close the window. Now right-click Solution 'Open MPI' again and hit Build Solution. It takes a while to compile everything. If you get errors about error code -31 and mt.exe at the end of the build, that's your virus scanner locking the new exe/dll files and the install project complains. Keep right-clicking and Build Solution until it goes through. The final Open MPI include files and binaries are in the C:\Users\Alex's\Downloads......\installed directory.
PS OpenMPI 1.4.2 doesn't have Fortran support on Windows. You need the dev 1.5 series for that and a Fortran compiler.
On 12/07/2010 11:35 AM, Alexandru Blidaru wrote:
I installed a 90 day trial of Visual Studio 2008, and I am pretty sure I am getting the exact same thing. The log and the picture are attached just as last time. Any new ideas?
users mailing list