I will resubmit a new patch, Rob sent me a pointer to the correct
solution. Its on my to do list for tomorrow/this weekend.
On 3/27/2014 5:45 PM, Dave Love wrote:
> Edgar Gabriel <gabriel_at_[hidden]> writes:
>> not sure honestly. Basically, as suggested in this email chain earlier,
>> I had to disable the PVFS2_IreadContig and PVFS2_IwriteContig routines
>> in ad_pvfs2.c to make the tests pass. Otherwise the tests worked but
>> produced wrong data. I did not have however the time to figure what
>> actually goes wrong underneath the hood.
> [I can't get into trac to comment on the issue (hangs on login), so I'm
> following up here.]
> In case it's not clear, the changes for 1.6 and 1.7 are different, and
> probably shouldn't be. The patch I took from 1.7 looked similar to
> what's in mpich, but hard-wired rather than autoconfiscated, whereas the
> patch for 1.6 on the tracker sets the entries to NULL instead.
>> On 3/25/2014 9:21 AM, Rob Latham wrote:
>>> On 03/25/2014 07:32 AM, Dave Love wrote:
>>>> Edgar Gabriel <gabriel_at_[hidden]> writes:
>>>>> I am still looking into the PVFS2 with ROMIO problem with the 1.6
>>>>> series, where (as I mentioned yesterday) the problem I am having right
>>>>> now is that the data is wrong. Not sure what causes it, but since I have
>>>>> teach this afternoon again, it might be friday until I can digg into
>>>> Was there any progress with this? Otherwise, what version of PVFS2 is
>>>> known to work with OMPI 1.6? Thanks.
>>> Edgar, should I pick this up for MPICH, or was this fix specific to
>>> OpenMPI ?
> users mailing list
Parallel Software Technologies Lab http://pstl.cs.uh.edu
Department of Computer Science University of Houston
Philip G. Hoffman Hall, Room 524 Houston, TX-77204, USA
Tel: +1 (713) 743-3857 Fax: +1 (713) 743-3335