Thanks, Jeff. I really understood the situation.
> This all seems to be a side-effect of r30942 -- see:
> On Mar 12, 2014, at 5:13 AM, <tmishima_at_[hidden]> wrote:
> > Hi Ralph,
> > I installed openmpi-1.7.5rc2 and applied r31019 to it.
> > As far as I confirmed, rmaps framework worked fine.
> > However, by chance, I noticed that single ctrl+c typing could
> > not terminate a running job. Twice typing was necessary.
> > Is this your expected behavior?
> > I didn't use ctrl+c to abort for a while, I don't know when
> > it started. At least I can terminate the job by single ctrl+c
> > if I use openmpi-1.7.4.
> > And, for your information, when I hit ctrl+c with more than 5
> > seconds interval, I get the message below:
> > Abort is in progress...hit ctrl-c again within 5 seconds to forcibly
> > terminate
> > Tetsuya
> > _______________________________________________
> > users mailing list
> > users_at_[hidden]
> > http://www.open-mpi.org/mailman/listinfo.cgi/users
> Jeff Squyres
> For corporate legal information go to:
> users mailing list