Open MPI logo

Open MPI User's Mailing List Archives

  |   Home   |   Support   |   FAQ   |   all Open MPI User's mailing list

Subject: Re: [OMPI users] compilation aborted for Handler.cpp (code 2)
From: Syed Ahsan Ali (ahsanshah01_at_[hidden])
Date: 2013-09-22 10:40:59


Its ok Jeff.
I am not sure about other C++ codes and STL with icpc because it never
happened and I don't know anything about STL.(pardon my less
knowledge). What do you suggest in this case? installation of
different version of openmpi or intel compilers? or any other
solution.

On Fri, Sep 20, 2013 at 8:35 PM, Jeff Squyres (jsquyres)
<jsquyres_at_[hidden]> wrote:
> Sorry for the delay replying -- I actually replied on the original thread yesterday, but it got hung up in my outbox and I didn't notice that it didn't actually go out until a few moments ago. :-(
>
> I'm *guessing* that this is a problem with your local icpc installation.
>
> Can you compile / run other C++ codes that use the STL with icpc?
>
>
> On Sep 20, 2013, at 6:59 AM, Syed Ahsan Ali <ahsanshah01_at_[hidden]> wrote:
>
>> Output of make V=1 is attached. Again same error. If intel compiler is
>> using C++ headers from gfortran then how can we avoid this.
>>
>> On Fri, Sep 20, 2013 at 11:07 AM, Bert Wesarg
>> <bert.wesarg_at_[hidden]> wrote:
>>> Hi,
>>>
>>> On Fri, Sep 20, 2013 at 4:49 AM, Syed Ahsan Ali <ahsanshah01_at_[hidden]> wrote:
>>>> I am trying to compile openmpi-1.6.5 on fc16.x86_64 with icc and ifort
>>>> but getting the subject error. config.out and make.out is attached.
>>>> Following command was used for configure
>>>>
>>>> ./configure CC=icc CXX=icpc FC=ifort F77=ifort F90=ifort
>>>> --prefix=/home/openmpi_gfortran -enable-mpi-f90 --enable-mpi-f77 |&
>>>> tee config.out
>>>
>>> could you also run make with 'make V=1' and send the output. Anyway it
>>> looks like the intel compiler uses the C++ headers from GCC 4.6.3 and
>>> I don't know if this is supported.
>>>
>>> Bert
>>>
>>>> Please help/advise.
>>>> Thank you and best regards
>>>> Ahsan
>>>>
>>
>>
>>
>> --
>> Syed Ahsan Ali Bokhari
>> Electronic Engineer (EE)
>>
>> Research & Development Division
>> Pakistan Meteorological Department H-8/4, Islamabad.
>> Phone # off +92518358714
>> Cell # +923155145014
>> <makeV.zip>_______________________________________________
>> users mailing list
>> users_at_[hidden]
>> http://www.open-mpi.org/mailman/listinfo.cgi/users
>
>
> --
> Jeff Squyres
> jsquyres_at_[hidden]
> For corporate legal information go to: http://www.cisco.com/web/about/doing_business/legal/cri/
>
> _______________________________________________
> users mailing list
> users_at_[hidden]
> http://www.open-mpi.org/mailman/listinfo.cgi/users

-- 
Syed Ahsan Ali Bokhari
Electronic Engineer (EE)
Research & Development Division
Pakistan Meteorological Department H-8/4, Islamabad.
Phone # off  +92518358714
Cell # +923155145014