Open MPI logo

Open MPI User's Mailing List Archives

  |   Home   |   Support   |   FAQ   |   all Open MPI User's mailing list

Subject: Re: [OMPI users] Cannot run MPI job across nodes using OpenMPI in F17
From: Ralph Castain (rhc_at_[hidden])
Date: 2012-12-13 09:37:56


What version of OMPI are you running? We stopped supporting bproc after the 1.2 series, though you could always launch via ssh.

On Dec 12, 2012, at 10:25 PM, Ng Shi Wei <nsw_1216_at_[hidden]> wrote:

> Dear all,
>
> I am new in Linux and clustering. I am setting up a Beowulf Cluster using several PCs according to this guide http://www.tldp.org/HOWTO/html_single/Beowulf-HOWTO/.
>
> I have setup and configure accordingly except for NFS part. Because I am not requiring it for my application. I have set my ssh to login each other without password. I started with 2 nodes 1st. I can compile and run in my headnode using openmpi. But when I try to run my MPI application across nodes, there is nothing displaying. It just like hanging there.
>
> Headnode: master
> client: slave4
>
> The command I used to mpirun across nodes is as below:
> Code:
> mpirun -np 4 --host slave4 output
> Since I not using NFS, so I installed OpenMPI in every nodes with same locations.
>
> I wondering I missed out any configurations or not.
>
> Hope someone can help me out of this problem.
>
> Thanks in advance.
>
> Best Regards,
> Shi Wei
> _______________________________________________
> users mailing list
> users_at_[hidden]
> http://www.open-mpi.org/mailman/listinfo.cgi/users