Am Freitag, den 27.03.2009, 11:01 +0800 schrieb Jerome BENOIT:
> Finally I succeeded with the sbatch approach ... when my firewall are
> stopped !
> So I guess that I have to configure my firewall (I use firehol):
> I have just tried but without success. I will try again later.
> Is there any other ports than the SLURM ones which are involved ?
On the SLURM side, you have to open the ports to the SLURM control
daemons and the service that handles the credentials. On Debian systems
Also, you need to open ports for the MPI processes to communicate. The
port range is rather wide, so the easiest setup (I guess) is to not use
a firewall between computing nodes.