I have myricom mx installed and configured and its communications work (using
mx commands such as mx_info to check)
Then I configured openmpi-1.3a1r12408 with mx and the configuration
did give no errors. The built of the openmpi was without problems and it
installed properly. I can build and link a program - and ldd shows the
openmpi libraries linked accordingly.
In order to run applications I set the LD_LIBRARY_PATH and the PATH correctly
but the command.
ompi_info | grep mx
[m2001:12844] mca: base: component_find: unable to open mtl mx: file not found
(ignored)
[m2001:12844] mca: base: component_find: unable to open btl mx: file not found
(ignored)
[m2001:12844] mca: base: component_find: unable to open mtl mx: file not found
(ignored)
and indeed the job does not run, if I give the instruction
-mca btl mx
Any idea why this should happen?
Lydia
------------------------------------------
Dr E L Heck
University of Durham
Institute for Computational Cosmology
Ogden Centre
Department of Physics
South Road
DURHAM, DH1 3LE
United Kingdom
e-mail: lydia.heck_at_[hidden]
Tel.: + 44 191 - 334 3628
Fax.: + 44 191 - 334 3645
___________________________________________
|
![[Flag]](../../../../../community/mirrors/flag-us.gif){kind=small}