Open MPI logo

Open MPI User's Mailing List Archives

  |   Home   |   Support   |   FAQ   |   all Open MPI User's mailing list

From: Jeffrey B. Layton (laytonjb_at_[hidden])
Date: 2006-04-11 19:42:35


Well, yes these nodes do have multiple TCP interfaces.
I'll give 1.0.2 a whirl :)

Thanks!

Jeff

> Do you, perchance, have multiple TCP interfaces on at least one of the
> nodes you're running on?
>
> We had a mistake in the TCP network matching code during startup -- this
> is fixed in v1.0.2. Can you give that a whirl?
>
>
>
>> -----Original Message-----
>> From: users-bounces_at_[hidden]
>> [mailto:users-bounces_at_[hidden]] On Behalf Of Jeffrey B. Layton
>> Sent: Tuesday, April 11, 2006 11:25 AM
>> To: Open MPI Users
>> Subject: [OMPI users] Problem running code with OpenMPI-1.0.1
>>
>> Good morning,
>>
>> I'm trying to run one of the NAS Parallel Benchmarks (bt) with
>> OpenMPI-1.0.1 that was built with PGI 6.0. The code never
>> starts (at least I don't see any output) until I kill the code. Then
>> I get the following message:
>>
>> [0,1,2][btl_tcp_endpoint.c:559:mca_btl_tcp_endpoint_complete_connect]
>> connect() failed with
>> errno=113[0,1,4][btl_tcp_endpoint.c:559:mca_btl_tcp_endpoint_c
>> omplete_connect]
>> connect() failed with
>> errno=113[0,1,8][btl_tcp_endpoint.c:559:mca_btl_tcp_endpoint_c
>> omplete_connect]
>> connect() failed with errno=113mpirun: killing job...
>>
>> Any ideas on this one?
>>
>> Thanks!
>>
>> Jeff
>> _______________________________________________
>> users mailing list
>> users_at_[hidden]
>> http://www.open-mpi.org/mailman/listinfo.cgi/users
>>
>>
>
> _______________________________________________
> users mailing list
> users_at_[hidden]
> http://www.open-mpi.org/mailman/listinfo.cgi/users
>
>