Hi again... I was on a break from Xensocket stuff.... This time some general questions...
me for the question.... its a quick one and related to some of my
development work on Xen, I will explain the rationale after the
question. What if I have multiple Ethernet cards (say 5) on two of my
quad core machines. The IP addresses
(and the subnets of course) are
Machine A Machine B
eth0 is y.y.1.a y.y.1.z
eth2 is y.y.4.c ...
eth3 is y.y.4.d ...
from the FAQ's/Some emails in user lists it is clear that if I want to run a job on
multiple ethernets, I can use --mca btl_tcp_if_include eth0,eth1. This
will run the job on two of the subnets utilizing both the Ethernet
cards. Is it doing some sort of load balancing? or some round robin mechanism? What part of code is responsible for this
what if I want to run the job like --mca btl_tcp_if_include
eth1,eth2,eth3,eth4. Notice that all of these ethNs are on same subnet.
Even in the FAQ's (which mostly answers our lame questions) its not
entirely clear how communication will be done. Each process will have
tcp_num_btls equal to interfaces, but then what? Is it some sort of
load balancing or similar stuff which is not clear in tcpdump?
related question is what if I want to run 8 process job (on 2x4
cluster) and want to pin a process to an network interface. OpenMPI to
my understanding does not give any control of allocating IP to a
process (like MPICH)
or is there some magical --mca thingie. I think only way to go is
adding routing tables... am i thinking in right direction? If yes, then
the performance of my boxes decrease when i trying to force the routing
(obviously something terrible with my configuration)
Its related to
my Xen (virtualization) work. We are in a scenario, where all the
virtual machines on one Xen host need to use eth2 (which is virtualized
but optimized for intra-domain communication) and for communication
outside the physical machine (i.e. to other Xen hosts) we want to use
eth1. Is 'route add' the only way again?
I will ask Xensocket BTL related questions later :)
Best Regards and thanks in advance,
PS: Sorry if you receive multiple messages..... I think my previous message did not go through.