Open MPI logo

Open MPI Development Mailing List Archives

  |   Home   |   Support   |   FAQ   |   all Development mailing list

Subject: Re: [OMPI devel] opal_process_info.job_session_dir: "not yet defined"
From: George Bosilca (bosilca_at_[hidden])
Date: 2014-07-28 13:10:34


This means you are trying to initialize things too early. Most of the
information made available in opal/util/proc.h is only available once the
RTE was setup, i.e. only after the call to rte_init. Thus, the BTL can only
use it after the init call...

  George.

On Mon, Jul 28, 2014 at 1:01 PM, Ralph Castain <rhc_at_[hidden]> wrote:

>
> On Jul 28, 2014, at 9:57 AM, Jeff Squyres (jsquyres) <jsquyres_at_[hidden]>
> wrote:
>
> > I'm getting a value of "not yet defined" for
> opal_process_info.job_session_dir in the usnic BTL (is this also what is
> happening for
> http://www.open-mpi.org/community/lists/devel/2014/07/15276.php?).
> >
> > Can the job_session_dir be define/setup before the BTLs are setup?
>
> Yes, but the BTL setup can't be done in opal_init - it'll have to be the
> responsibility of the RTE layer to first set things up, and then init the
> BTLs. George asked me to look into this, and I will - just slammed today
> and so can't get to it until later this afternoon
>
> >
> > --
> > Jeff Squyres
> > jsquyres_at_[hidden]
> > For corporate legal information go to:
> http://www.cisco.com/web/about/doing_business/legal/cri/
> >
> > _______________________________________________
> > devel mailing list
> > devel_at_[hidden]
> > Subscription: http://www.open-mpi.org/mailman/listinfo.cgi/devel
> > Link to this post:
> http://www.open-mpi.org/community/lists/devel/2014/07/15277.php
>
> _______________________________________________
> devel mailing list
> devel_at_[hidden]
> Subscription: http://www.open-mpi.org/mailman/listinfo.cgi/devel
> Link to this post:
> http://www.open-mpi.org/community/lists/devel/2014/07/15279.php
>