Open MPI logo

Open MPI Development Mailing List Archives

  |   Home   |   Support   |   FAQ   |   all Development mailing list

Subject: Re: [OMPI devel] [EXTERNAL] SPARC V8+ question
From: Barrett, Brian W (bwbarre_at_[hidden])
Date: 2014-01-29 18:45:11


Paul -

Can you send me the config.log from this failure?

Thanks,

Brian



Sent with Good (www.good.com)


-----Original Message-----
From: Paul Hargrove [phhargrove_at_[hidden]<mailto:phhargrove_at_[hidden]>]
Sent: Wednesday, January 29, 2014 04:11 PM Mountain Standard Time
To: Open MPI Developers
Subject: [EXTERNAL] [OMPI devel] SPARC V8+ question

I know Open MPI dropped support for the SPARC V8 ABI some time ago.
So, I configured with CC="gcc -mv8plus", but I still get:

checking if have Sparc v8+/v9 support... no
configure: WARNING: Sparc v8 target is not supported in this release of Open MPI.
configure: WARNING: You must specify the target architecture v8plus
configure: WARNING: (cc: -xarch=v8plus, gcc: -mcpu=v9) for CFLAGS, CXXFLAGS,
configure: WARNING: FFLAGS, and FCFLAGS to compile Open MPI in 32 bit mode on
configure: WARNING: Sparc processors
configure: error: Can not continue.

So, I am wondering if there is something flawed in the "have Sparc v8+/v9 support" or if gcc's "-mv8plus" is flawed.
Of course, I will follow the advise in the warning and use -mcpu=v9 instead of -mv8plus, but don't see why the later didn't work. Any ideas what is going on?

And since this was found in 1.7.4rc2:
WOULD SOMEBODY PLEASE REMOVE "FFLAGS" FROM THAT MESSAGE!!

-Paul

--
Paul H. Hargrove PHHargrove_at_[hidden]<mailto:PHHargrove_at_[hidden]>
Future Technologies Group
Computer and Data Sciences Department Tel: +1-510-495-2352
Lawrence Berkeley National Laboratory Fax: +1-510-486-6900