To enable the debug mode you should configure Open MPI with --enable-debug. After compilation just run the test with gdb, and export a backtrace (gdb command bt or where).
On Oct 14, 2013, at 11:44 , Syed Ahsan Ali <ahsanshah01_at_[hidden]> wrote:
> George Can you please tell me how to run test in debug mode?
> On Fri, Oct 4, 2013 at 3:42 AM, George Bosilca <bosilca_at_[hidden]> wrote:
>> The output seems normal, there is no indication of anything weird happening. Also I tried to reproduce the error with other icc versions to no avail.
>> Can you run the test in debug mode inside gdb? When the segfault happen please get the stack trace (gdb command where or bt) and send it to me.
>> On Oct 3, 2013, at 13:06 , Jeff Squyres (jsquyres) <jsquyres_at_[hidden]> wrote:
>>> George --
>>> See this thread on the users list:
>>> Thread starts here:
>>> Relevant messages start here:
>>> Attached is a zip file from the user experiencing a failure in "make check" in opal_datatype_test. I think he may have run "make -j X check" because the output is a little jumbled.
>>> I'm unable to replicate the error on RHEL6/icc 14.0.
>>> Have you see this kind of failure before in opal_datatype_test / have any idea how the error indicated in the output can happen?
>>> Jeff Squyres
>>> For corporate legal information go to: http://www.cisco.com/web/about/doing_business/legal/cri/
>>> devel mailing list
> Syed Ahsan Ali Bokhari
> Electronic Engineer (EE)
> Research & Development Division
> Pakistan Meteorological Department H-8/4, Islamabad.
> Phone # off +92518358714
> Cell # +923155145014