Gaah! I specifically asked Patrick and George about this and they
said that the README text was fine. Grr...
I'll update.
On Jan 13, 2009, at 3:38 PM, Bogdan Costescu wrote:
> On Tue, 13 Jan 2009, Brian W. Barrett wrote:
>
>> The bottom line, however, is that the OB1 PML will be the default
>> *UNLESS* the PSM (PathScale/Qlogic) MTL can be chosen, in which
>> case the CM PML is used by default.
>
> OK, then the README file is wrong or I don't read it properly... In
> the section "Network Support", there is a paragraph saying:
>
> Open MPI will, by default, choose to use "cm" if it finds a
> cm-supported network at run-time.
>
> With the MX MTL being available at run-time, I would expect CM to be
> chosen based on the quoted paragraph.
>
> --
> Bogdan Costescu
>
> IWR, University of Heidelberg, INF 368, D-69120 Heidelberg, Germany
> Phone: +49 6221 54 8240, Fax: +49 6221 54 8850
> E-mail: bogdan.costescu_at_[hidden]
> _______________________________________________
> devel mailing list
> devel_at_[hidden]
> http://www.open-mpi.org/mailman/listinfo.cgi/devel
--
Jeff Squyres
Cisco Systems
|
![[Flag]](../../../../../community/mirrors/flag-us.gif){kind=small}