It couldn't be easier. Thanks a lot!
On Friday 22 June 2007 00:32:13 George Bosilca wrote:
> Rerun the autogen.sh script and the new BTL will get auto-magically
> included in the build. You don't have to modify anything, just run
> the script.
> Once you get it compiled, you can specify --mca btl <whatever>,self
> on your mpirun command line to get access at runtime to your BTL.
> On Jun 21, 2007, at 3:36 PM, pcascon_at_[hidden] wrote:
> > Hello all,
> > I just arrived to open-mpi. I'm trying to create a new btl. The
> > goal is
> > to use open-mpi with a library that sends/receives packets with a
> > network processor (IXP) based board. Since it's an ethernet board I
> > thought the best way to start it's to reproduce the TCP btl. So I made
> > a copy of the directory ompi/mca/btl/tcp/ just to have something to
> > start. But then, I don't know how to include this "new" btl into the
> > build system (./configure ; make all install). My knowledge about the
> > GNU autotools it's not good enough I guess. I believe first step it's
> > to modify the configure script through 'autoconf' but not sure how to
> > do this. I've been searching for information about that on this
> > maillist with no luck. What will be the steps to create a basic btl?
> > What's the best way to integrate the code onto the whole open-mpi?
> > Thanks a lot for reading :)
> > Regards
> > Pablo
> > _______________________________________________
> > devel mailing list
> > devel_at_[hidden]
> > http://www.open-mpi.org/mailman/listinfo.cgi/devel