Open MPI logo

Open MPI Development Mailing List Archives

  |   Home   |   Support   |   FAQ   |   all Development mailing list

From: Ralph Castain (rhc_at_[hidden])
Date: 2006-11-30 10:12:16


That could be the problem. I had to update automake, and unfortunately
Darwin Ports hasn't reached that level yet. So I had to build and install
automake by hand under my own bin directory. But libtool etc are all in
/usr/bin.

I'll give your suggestion a shot later - gotta run.

Thanks
Ralph

On 11/30/06 8:06 AM, "Ralf Wildenhues" <Ralf.Wildenhues_at_[hidden]> wrote:

>> * Ralph Castain wrote on Thu, Nov 30, 2006 at 03:55:05PM CET:
>>>
>>> configure.in:1994: warning: macro `AM_PROG_LIBTOOL' not found in library
>>> [Running] autoheader
>>> [Running] autoconf
>>> configure.in:1997: error: possibly undefined macro: AM_PROG_LIBTOOL
>>> If this token and others are legitimate, please use m4_pattern_allow.
>>> See the Autoconf documentation.
>
> Another question: does the aclocal from Automake 1.10 find the
> libtool.m4 file from your Libtool installation? IOW, if Libtool
> and Automake are not installed below the same $prefix, then you
> need to do something: either put the path to libtool.m4 in the
> file $automake_prefix/share/aclocal/dirlist, or pass some -I
> parameters to aclocal.
>
> Hope that helps.
>
> Cheers,
> Ralf
> _______________________________________________
> devel mailing list
> devel_at_[hidden]
> http://www.open-mpi.org/mailman/listinfo.cgi/devel