From: Jeff Squyres (jsquyres_at_[hidden])
Date: 2006-10-02 09:57:55
Hrm. Well, the lack of "success=1" is why it didn't run, but then the
larger question becomes "why didn't it succeed?".
Do you have --verbose or --debug output for the build, perchance? If it
failed to build, there should be some output about it.
On 10/1/06 7:32 PM, "Josh Hursey" <jjhursey_at_[hidden]> wrote:
> So I dug into this about as much as I can, and found that the v1.1
> build seems to have completed successfully, but doesn't contain the
> 'success = 1' line. I attached the build dumps in case that helps
> figure this one out.
>
>
> Any thoughts on why this might happen,
> Josh
>
> On Sep 29, 2006, at 3:40 PM, Josh Hursey wrote:
>
>> Has anyone been using MTT to test the v1.1 nightly?
>>
>> I have been trying to run the [trivial,ibm] tests against
>> [trunk,v1.2,v1.1]. MTT will build all the sources and all the tests
>> with all the sources. It will then run the trivial tests against all
>> three sources, but only the ibm tests against the trunk and v1.2.
>>
>> I looked at the logs produced and there didn't seem to be any errors
>> with the ibm+v1.1 test build. Would there be any other reason this
>> would happen?
>>
>> ----
>> Josh Hursey
>> jjhursey_at_[hidden]
>> http://www.open-mpi.org/
>>
>> _______________________________________________
>> mtt-users mailing list
>> mtt-users_at_[hidden]
>> http://www.open-mpi.org/mailman/listinfo.cgi/mtt-users
>
> ----
> Josh Hursey
> jjhursey_at_[hidden]
> http://www.open-mpi.org/
>
> _______________________________________________
> mtt-users mailing list
> mtt-users_at_[hidden]
> http://www.open-mpi.org/mailman/listinfo.cgi/mtt-users
-- Jeff Squyres Server Virtualization Business Unit Cisco Systems